Menu
Panier 0

Z-Monitor

  • 120.00 € Prix affiché H.T


Les Z-Monitor sont Disponible !

Now, thanks to Z-Mon, you can start long prints or partial spools with confidence - if the material runs out, Z-Mon will automatically pause your M200®, allowing you to add more filament and resume printing at your convenience!

Exclusive Clip-On Design

Unique among filament monitors, Z-Mon features a clip-on design that eliminates the need to thread the filament through the sensor. With other monitors you need to remember to thread the filament through before starting a print; if you forget, you have to pause your print, unload the filament, thread it through the monitor, reload the filament, and resume your print. With Z-Mon you can clip the monitor on whenever you need it, even mid-print.

Fully Assembled, Installs Easily in Minutes, Without Permanent Modifications to the

 

Printer

Z-Mon requires no assembly, no soldering, no g-code, and no permanent modifications to the printer. Just remove the bottom cover, plug in the Z-Mon interface board, connect the sensor cable, and replace the bottom cover.

Simple to Operate

There’s no finicky calibration, no motion-sensing rollers, no false alarms, no timeouts to adjust. Just clip it on and start your print. If the filament runs out, the printer will pause and wait for your instructions.

Flexible Mounting Options

Z-Mon can be clipped onto the filament anywhere that the included 1.5m cable will reach. Works with rear-mounted spools or overhead feed. Z-Mon comes with two mounts: one designed to conveniently clip onto the printer's ribbon cable, and another that snaps into the guide tube mounting slot on the rear of the printer.

Kit Includes:

  • Z-Mon Sensor
  • Interface Board (plugs into motherboard)
  • 1.5m Sensor Cable
  • Two mounting clips: ribbon cable and rear chassis

Nous vous recommandons également